Guide · GM

How to decode a Chevrolet VIN and cowl tag: 1964–72 Chevelle and 1967–69 Camaro

Reviewed November 19, 2026. Facts are limited to what the sources listed at the bottom support. Year, plant, and model exceptions are common.

A Chevrolet VIN plate and a Fisher cowl tag are two different factory documents. They sit a few feet apart and share a year and a plant, so they are easy to mash into one “decode.” That is how people talk themselves into a Z/28 or an SS the numbers never claimed.

A decode is a reading of factory codes. It is not proof that a car is genuine, and it is not by itself a numbers-matching check. This guide covers Chevelles from 1964 to 1972 and first-generation Camaros from 1967 to 1969. It does not cover other Chevrolet lines.

After you finish here, use the multi-make checklist for the full field sequence. The GM identification hub is the shorter, bookmarkable version.

What a Chevrolet VIN can and cannot tell you

The Camaro Research Group (CRG) is blunt about first-generation Camaros. The VIN gives division, car line, six-cylinder or V8, coupe or convertible, model year, assembly plant, and a sequence number. In CRG’s words, “The VIN does not tell if the car is a Z28, SS, RS, etc.” That one sentence settles a lot of classified ads.

A Chevelle VIN can say more about the SS question in some years. In 1967 and 1968, series 38 is the SS396 series, which also includes the V8 Concours station wagon. ChevelleStuff notes that the 396 could be ordered only in SS396 coupes, convertibles, and (in 1968) the pickup, plus the El Camino in 1967. Even so, the plate is not a complete option list, and the series digits on a VIN do not mean the same thing as the series on the Fisher cowl tag. ChevelleStuff repeats that warning on its VIN pages.

Where the official VIN plate is

The location and the attachment method change in this period.

ChevelleStuff’s 1970 page shows two different styles of riveting on original plates, so compare any plate you doubt with documented examples for the same year and plant.

1964 uses its own VIN layout

It is easy to memorize the later 13-character pattern and force a 1964 plate into it. Do not. ChevelleStuff documents a 12-character U.S. layout that starts with the model year rather than a GM division digit. Its example is 45635K183855, a Malibu V8 four-door two-seat station wagon assembled in Kansas City:

GM of Canada plates differ again: ChevelleStuff says they carry only a five-digit sequence number. A “13-character 1964 Chevelle VIN” that starts with 1 does not match this documented U.S. layout.

The 13-character VIN, 1965–71

From 1965 through 1971, U.S. Chevelle VINs share one 13-character pattern: division (1 = Chevrolet), a two-digit series, a two-digit body style, the model-year digit, the assembly plant letter, and a six-digit sequence. Plant letters and body codes vary by year, so use that year’s table. ChevelleStuff’s worked examples show how the digits move:

On these VINs, an odd third digit means a six-cylinder and an even third digit means a V8. That rule belongs to the VIN, not the cowl tag.

The last six digits are an assembly-plant sequence that runs across series and body styles. It is not a separate SS or Malibu counter. The same last six digits can appear at more than one plant, and only the plant letter tells those cars apart. Start numbers for Chevelles were 100001 through 1968 and 300001 in 1969, according to ChevelleStuff. When a plant built more than 100,000 cars in a model year, the sequence rolled into the 200000s. In 1968 that happened at Baltimore in May and at Kansas City in April.

Canadian-built cars often use a different schema. ChevelleStuff’s 1964 and 1965 pages show Oshawa plates that are not simply U.S. plates with a different plant code.

1972 changed the Chevelle VIN

The 1972 Chevelle plate is coded differently, according to ChevelleStuff. A single letter replaces the two-digit series (B, C, D, or H), the body style stays two digits, and a new letter in the fifth position shows the engine installed. Earlier years showed only six-cylinder or V8 through the odd-or-even third digit. ChevelleStuff’s example is 1D37U2L585744: Chevrolet (1), Malibu (D), sport coupe (37), 402 four-barrel (U), 1972 (2), Van Nuys (L). Chevelle sequence numbers start at 500001 in 1972. So the odd-or-even rule above does not apply to a 1972 car.

Camaro VINs, 1967–69

CRG gives the first-generation Camaro pattern as 12ebbYPxxxxxx, for example 124379N506070:

CRG notes that Norwood built more than 100,000 Camaros a year, so 1968 Norwood sequences run on into the 400000s. A partial VIN should also be stamped on the body: on the cowl in front of the passenger side (under the cowl vent panel) and on the firewall below the fan or heater opening. CRG warns that partial VINs on engines and transmissions can be restamped.

Nova and Chevy II cars are not covered here. ChevelleStuff’s 1968 sequence table lists Chevy II sequences starting at 200001, but a Nova needs its own year-specific source.

How to read the Fisher cowl tag

The cowl tag, also called the trim tag or Fisher Body number plate, is a small aluminum tag. On first-generation Camaros, CRG places it on the driver’s side of the firewall in the engine compartment, by the master cylinder. Fisher Body stamped it, not the Chevrolet assembly division, which is why the style code is not a copy of the VIN.

Fields CRG describes for 1967–69 Camaros, and ChevelleStuff describes for 1968 Chevelles, include:

The style code is not the first five digits of the VIN

CRG explains that Fisher did not need the engine type on the cowl tag, so the third digit of the style code means something else. In 1967, Camaro style codes were 12x37 or 12x67, with the third digit 4 for a standard interior or 6 for a custom interior. A 1967 convertible with a custom interior reads 12667. In 1968–69, every Camaro, six-cylinder or V8, carried style 12437 or 12467, with the third digit fixed at 4 and no engine meaning.

ChevelleStuff says the same for Chevelles: the third digit on the trim tag does not identify six-cylinder or V8. It also says some 1968 plants used an odd third digit in the style number. Oshawa is documented, and Fremont is suspected because it did so in surrounding years. That is a plant habit, not a six-cylinder flag. If a seller points to “12437” on a 1968 or 1969 Camaro tag as proof of a V8, they are reading a Fisher style code as if it were a VIN.

Year-specific cowl-tag extras

1967 option codes. 1967 is the only year whose Camaro cowl tag lists Fisher body option codes. Examples include tinted glass, console, fold-down rear seat, air conditioning, the Rally Sport package, and engine-reinforcement codes. CRG confirmed many from Uniform Option Identification Tags found in cars and inferred the rest statistically. Early Van Nuys and Norwood SS350 cars may lack the 4P code, so a missing code does not always mean a missing option. The list ended in 1968.

1969 X codes. Norwood began stamping X codes starting with the 12B (second week of December) build week. X11, X22, and X33 are in the Z21 style-trim group (which includes Rally Sport), and X44, X55, X66, and X77 are not. X22 and X66 are SS396, X33 and X77 are Z28, and X55 is SS350 without style trim. X11 is not automatically an SS: CRG estimates only about one in ten X11 cars is an SS350. Most COPO Camaros came from X11 or X44 bodies. Norwood used Z10 and Z11 for Indy Pace Car replica bodies. Chevelle trim tags vary by plant, so use plant-specific Chevelle examples rather than a Camaro layout.

What to do after the two plates agree, and when they do not

If the VIN year, plant, and body style fit the cowl tag’s year, plant, style, and build week, you have a coherent body story, not an appraisal. Next come hidden partial VINs, engine and transmission stamps, and date codes. ChevelleStuff’s 1968 page shows a Baltimore example of a partial VIN behind the heater box but notes it is not certain that every plant stamped one. See the GM hub and the checklist for those steps.

If the plates disagree on plant, body, or a build week that cannot work with the sequence, do not talk yourself out of it. Reproductions exist, and tags get swapped along with fenders and firewalls. Paperwork helps: CRG describes the Chevrolet Protect-O-Plate as carrying the VIN along with engine, carburetor, transmission, and axle codes and the month of manufacture. For Pontiacs such as the GTO, do not reuse Chevrolet series codes. Pontiac Historical Services sells an information packet that includes the factory invoice or billing history and a letter decoding the options.

Ford and Mopar cars do not use this layout. See the Ford and Mopar hubs.

Sources

All text on this page is original. Found an error? Email factorydecodess@gmail.com and we will check it against the sources. Corrections are made promptly and noted on the page. See our contact page for the full corrections policy.